| 1.01.00 |
'07.05.30 |
Major Updates
- The stage setup screen operations such as element definitions, analysis conditions, and water pressure settings in the Pre section have been made faster.
- In the Pre section, nodes can be added on the water level line.
- In the Pre section, added control for cases where the total release ratio exceeds 1.0 on the input screen for the stress release ratio.
- In the Pre section, a new "rectangle selection (box enclosure) mode" is available to select only the area enclosed by a rectangle.
- Coordinate axis display is now supported in the Pre section.
- Added a button to register regular polygons in the Pre part model creation.
- The number of nodes and elements are now displayed in the Pre section.
- Product help is now available in HTML format (for Vista).
Fixed Problems
- Fixed a bug that caused a module address violation when reading a file with a lowercase data extension (gf2).
- Fixed a problem in which water pressure was not set correctly in the analysis data when the calculation of nodal water pressure was not performed in the water pressure setting screen in Pre processing.
- In the "Add Midpoint" command of the "Create Model" or "Set Water Pressure" menu, for example, if the command is executed for a line segment with node number 1-2, the line segments would normally be 1-2, 2-3, but they were 1-2, 3-4. Fixed.
- Fixed a problem in which the water level line (continuous line) was disrupted after changing the coordinate values in the water level line registration.
- Fixed a bug in which the analysis results were not symmetrical despite the flat water level condition.
Modification in Help
- Overview - Versions and improvements - Ver1.1.0
|
Product Information
